Sartorius LP Models - Practical Example: Recalculation; Recalculation for Over-Poured Components

53
Operating the Balance
Practical Example
When weighing in formulation components, the second component is over-poured.
(Parameter settings: Recalculation application: 2 1 9; Print all parameters: 7 1 2)
Step Key (or instruction) Display/Output
—————————————————————————————————————————————————
1. Select the recalculation see “Preparation”
application in the Setup menu
2. Place container for filling Place empty container
components on the balance on the balance
3. Tare t
4. Add the first component Weigh the first component
into the container
5. Store component Press the comp.1
soft key (v)
6. Add the second component Weigh the second
component into the container
7. Start recalculation, because recal soft key (q)
12.42 g were poured rather
than 12.30 g
8. Either press the minus minus soft key repeatedly
key to correct the value...
store comp.1
store comp.1
store comp.1
recal. add. comp.2
minus plus comp.2
minus plus comp.2
Comp1 + 27.08 g