Sartorius MA35M-230N - Display

20
19
Display
The texts and symbols shown on the display
always have the same meaning. The display
is divided into several areas.
Drying parameters/Adjustment function
Busy symbol,
plus/minus sign,
standby symbol
Result
Unit
Graphic
symbols
Function line
Drying parameters:
The following symbols indicate drying pro-
gram parameters for information, selection
and configuration:
120
°
C Target temperature
40min Drying time
A Fully automatic
g Weight unit or unit
for a calculated value
A Analysis start
2.0min Interval for automatic
output of intermediate
results
Adjustment function:
b Adjustment function
Busy symbol, plus/minus sign,
standby symbol:
The
J
symbol is shown here when the
moisture analyzer is processing a function.
The plus/minus sign for the weight value
or calculated value appears here as well,
and the standby symbol when the device is
switched off.
Result:
This section shows the weight or calculated
value.
Unit:
When the weighing system stabilizes, the
unit of measurement for the weight or
calculated value is displayed here.
Graphic symbols:
Which symbol is shown here depends on
the operating status of the analyzer. The
examples below indicate “Please close
hood,” “Heating the sample” and “Please
wait” (hourglass).
Function line:
Press the Down/Back or Up/Forward keys
to move the focus and select one of the
functions shown here, and the Enter key to
activate the selected function:
WMA6030-e181002_1000034789.indd 19 09.10.18 15:32