27
Operation
Example: Analysis with Specified Drying Time
The specified drying time in the example is 10 minutes.
Heating temperature: 130°C
Start of analysis: Without stability after the cover is closed
End of analysis: After 10 minutes
Display mode: Moisture
Step Key (or instruction) Display
1. Switch on the moisture e Self-test runs
analyzer
2. Set the drying parameters
(see “Setting the Drying
Parameters” in the chapter
entitled “Configuration”)
3. Open the sample chamber and
place an unused sample pan
on the pan support
4. Tare the sample pan: or
select TAR as needed
...and confirm
5. Distribute approx. 2 g sample
evenly on the sample pan
6. Close the sample chamber
The printout header is printed:
see next page
To Next Page
Loading...
