SARTORIUS Portable and Gold
9
Balance/Scale Operating Menu
In the balance/scale operating menu, you can change individual code settings regarding the weight unit, balance/
scale response, display response, data output parameters and application parameters.
For the factory-set menu codes, please refer to „Overview of the MP 10.3 Menu“ (see page 11).
- The „codes“ for the menu settings are used to select the various functions in
the balance/scale operating menu. Each code consists of a left-hand
number for the function group (level 1—block) and a right-hand number for
a function within a group (level 2—function).
Accessing the Balance/Scale Operating Menu and Changing Menu Code Settings
Please proceed as follows to access the balance/scale operating menu:
- Switch balance/scale to the STANDBY mode by pressing the key.
- In order to gain access to the balance operating menu, remove the
protective cover (114) located on the front right-hand side of the balance/
scale and push the menu access switch to the left.
- When you turn the balance/scale back on by pressing the key,
simultaneously hold down the
T
control. Release the
T
control only
once the readout shown on the left is indicated in the display.
- Then the first level (block) of the balance/scale operating menu will be
indicated.
If you would like to check or change a menu code setting, proceed as follows:
- To increase the digit displayed for the block, press the
F1
key.
- To decrease the digit displayed for the block, press the
F2
key.
To Next Page
Loading...
Need help?
General