Sartorius Quintix - Individual Identifiers (Secura Only)

45
Weighing
User Manual Secura
®
, Quintix
®
, Practum
®
7.3 Individual Identifiers (Secura
®
only)
Purpose: You can define identifiers for the following print jobs:
– Device identification (ID): printed in header of GLP printout.
– Additional ID (A ID): printed in header of GLP printout.
– Batch ID (LID): queried after each GLP head in GLP printout at beginning of
measurement.
– Sample ID (SID): for printouts via the g button. This ID is queried before each
printout.
Prerequisites: – The balance must be connected to a Sartorius lab printer or PC for printouts (see
“USB Port” on page 79).
– The settings for individual identifiers can be configured in the system settings
under Identifier (see “Identifier (Secura
®
only)” on page 35).
– The GLP printout can be activated in the system settings under Print function in
Manual print (see “Printout” on page 34).
Starting the Printout
Example: Configuration of system settings for printing sample ID (SID):
Identifier – Sample ID function – Autom. increment:
t Place the sample on the weighing pan.
14.42
Max 2100 g d
=
0.01 g
+
t Select g to print.
1
S ID
1 2 3
4 5 6
7 8 9
- 0 .
C
y The identifier for the printout is displayed.
The displayed value can be changed if desired.
– Delete the last character: Select k.
t Select l to confirm.
y The weight value is printed. A sample printout can be seen below:
------------------
S ID 11
N + 200.21 g
S ID 12
N + 200.19 g