Need help?Do you have a question about the Sartorius Talent TE153S-DS and is the answer not in the manual?
General| Maximum Capacity | 150 g |
|---|---|
| Readability | 0.001 g |
| Display | LCD |
| Repeatability | 0.001 g |
| Linearity | ±0.002 g |
| Stabilization time (typical) | 2 s |
| Interface | RS232 |
| Operating Temperature | 10 °C to 40 °C |
| Calibration | Internal |
| Power Supply | AC adapter |
| Units | g, oz, lb |
Step-by-step guide to connect and activate the BPI mode for service software use.
Outlines setup, warm-up, and required checks like overload stop, zero-point, repeatability, etc.
Details how to measure and adjust the zero-point offset voltage using a DVM.
Details the process of adjusting off-center loading error using screws after opening the balance.
Lists common error codes, their causes, and recommended solutions for troubleshooting.
To Next Page