Need help?Do you have a question about the Sartorius Talent TE6100 and is the answer not in the manual?
Critical information for personnel servicing balances/scales, requiring prior service course completion.
Guidance on ordering and replacing the main PCB, including necessary model and serial number details.
Procedure for adjusting zero-point offset using DVM and balancing resistor R29.
Procedure for checking repeatability using test weights, calculating S, and identifying causes for exceeding tolerances.
Procedure for checking off-center error by placing test weights in different positions on the pan.
Method for adjusting off-center error by filing a thin part on the strain-gauge load receptor.
Procedure for checking linearity using specific steps and comparing with tolerance ranges.
Using service software to adjust linearity after checking span and activating BPI mode.
Steps to open the balance, access adjustment screws, and prepare for 3-point measurement.
Table detailing weighing capacity, readability, test weights, tolerances, span, and linearity for specific models.
Table detailing weighing capacity, readability, test weights, tolerances, span, and linearity for remaining models.
To Next Page
General