Need help?Do you have a question about the Sartorius Talent TE6101 and is the answer not in the manual?
Steps to activate BPI mode including self-test, button presses, and returning to SBI mode.
Procedure for checking and resetting the overload stop after system replacement.
Detailed steps for adjusting the overload stop using stop screws and test weights.
Procedure for adjusting zero-point offset, including DVM connection and target values.
Procedure for checking off-center error by placing test weights in different positions.
Method for adjusting off-center error by filing thin parts on the strain-gauge load receptor.
Steps for span adjustment using the operating menu and calibration weights, including important notes.
Procedure for checking linearity using specified steps and comparing with tolerance ranges.
Method for adjusting linearity using the service software and BPI mode.
Steps for checking off-center error on different weighing pan types using test weights.
Procedure for adjusting off-center error on double lever systems using adjustment screws.
Detailed steps for performing a 3-point measurement to determine and adjust off-center loading error.
Procedure for adjusting off-center error by filing thin parts on specific balance models.
Steps for span adjustment using the operating menu and calibration weights for double lever systems.
Procedure for checking linearity on double lever systems according to WKD-038.
Method for adjusting linearity using service software and BPI mode for double lever systems.
Steps for reading out data, replacing the main PCB, and programming the new PCB.
List of error codes, their causes, and recommended solutions for common balance issues.
List of additional error codes, their causes, and solutions for specific balance malfunctions.
To Next Page
General