Charging the Batteries
If the LED is red (not flashing), the batteries are com-
pletely drained.
$ The LED flashes red to indicate that the batteries are
charging; do not switch off the weighing instrument.
> The batteries are charged while the weighing instru-
ment is in standby mode
> It takes 28 hours to charge the batteries to full capacity
$ If the LED does not stop flashing red within a maxi-
mum of 3 hours, replace the batteries
Replacing the Batteries
!Avoid draining the batteries completely, as this will
reduce their recharging capacity.
!Use only size AA rechargeable nickel-metal hydride
batteries (see “Accessories”; order no. 69Y03136).
§ Lift the cover of the paper roll compartment
§ To open the battery compartment, tilt back the cover
!Remove the 4 batteries
Do not dispose of batteries in normal household waste.
Rechargeable batteries contain toxic materials and must
be disposed of in accordance with local waste disposal
regulations.
$ If you have any questions, please contact your local
Sartorius Service Center
§ Place the 4 new batteries in the battery compartment.
Make sure that the poles match the + and – signs
§ Press down on the cover to close the battery compart-
ment
§ Close the paper roll compartment
12
To Next Page
Loading...
