Satec EM132 User Manual

Chapter 5 Configuring the EM13X Series Configuring Communications
EM13x Series SMART MULTIFUNCTION METER 79
Figure 5-4: eXpertPower Client Setup Tab
The following table lists available options. Refer to your eXpertPower
service provider for the correct network settings.
Table 6: eXpertPower Client Setup Options
Parameter
Options
Default
Description
XPW Server IP Address
207.232.60.18
The IP address of the
eXpertPower server
XPWServerPort
0-65535
5001
The TCP service port of the
eXpertPower server
XPW Client Enabled
NO, YES
NO
Enables operations of the
eXpertPower client
Time to Next Session,
min
1-99999
The time remaining to the
next connection session
NOTES
 Do not enable the eXpertPower client in your meter if you do not use the
eXpertPower
TM
service.
 Do not change the connection time setting. It is for information only. The
eXpertPower server updates it automatically.
Setting Up TCP Notification Client
The TCP notification client can establish connections with a remote
Modbus/TCP server and send notification messages either on events,
or periodically on a time basis.
To set up communications with a remote TCP Notification server, select
Communication Setup from the Meter Setup menu, and then click
on the TCP Notification Client Setup tab.
Figure 5-5: TCP Notification Client Setup Tab
The following table lists available client options.

Satec EM132 Specifications

General

Brand	Satec
Model	EM132
Category	Measuring Instruments
Language	English