Section Two
28
www.Satloc.com Falcon User Manual, Rev A
e vertical blue LEDs at the extreme right and le can be used
as visual guidance for vertical oset from an AgLaser Input. If
AgLaser is selected, the user should enter the ideal application
height and a smaller acceptable tolerance above or below that
height. Within that tolerance, the blue LEDs will track similarly
to a bubble level (only vertical). Outside that tolerance, the LEDs
will scroll at increasing rates as the actual AgLaser height moves
further from the ideal application height.
Side Bars
e Center Circle of colorful LEDs displays two kinds of
information: trigger and obstacles. Here in the Lightbar settings,
only the Trigger information is set. A user can set the type of
visual trigger to ‘Distance,’ ‘Time,’ or ‘None.’
Distance and Time triggers cause a half-circle “smile” to visibly
change, allowing the pilot to anticipate events. For the smile to
work, it must be on Constant Rate Poly or Variable Rate Polygon.
e smile starts with the side-most LEDS and continue to light
LEDs to the middle so that the very Center LED lights at the
precise trigger moment. For Distance, the Start and Stop triggers
are set in length. For Time, the Start and Stop triggers are set in
seconds.
Center Circle
Lightbar Display
Creating a Lightbar Display Setup for
each Guidance Mode is ideal.
To have a particular setup loaded upon a specic
Guidance Mode, select it to be that mode’s default.
Detailed instructions are located later in this section.
NOTE
Satloc recommends
setting up custom
Lightbar Settings for all
likely application types (Liquid,
Dry Gate, etc.) and a Display
Setting for Ferrying.
TIP
Navigate to custom displays: Main Menu > Lightbar > Lightbar Display.
A pilot can enter and save multiple setups, so your name could be
specic. For example, “Bob’s Liquid” or “Liquid for Forestry.”
To Next Page
Loading...
