To Next Page
M
Michael VazquezAug 30, 2025
What to do if my SATO Label Maker shows a download error?
- RRonald LozanoAug 30, 2025
If your SATO Label Maker shows a download error, it means that you downloaded wrong data. Please, download again.
What to do if my SATO Label Maker shows a download error?
If your SATO Label Maker shows a download error, it means that you downloaded wrong data. Please, download again.
What to do if my SATO Label Maker displays a buffer over error?
If your SATO Label Maker shows a 'Buffer over' error, it means the amount of data received exceeds the limit of the receive buffer, or the protocol is wrong. Correct the software on the host side or set the correct protocol to resolve this.
How to fix dim print images on my SATO Label Maker?
If the SATO Label Maker displays dim print images, adjust the darkness level setting to increase the print head darkness.
What to do if my SATO Label Maker displays a ribbon end error?
If your SATO Label Maker displays a 'Ribbon end' error, it means the ribbon is either out or ripped, or it's not set properly. To fix this, ensure you set the ribbon correctly.
What to do if my SATO Label Maker shows a paper end error?
If your SATO Label Maker runs out of paper, set the paper properly.
What causes a 'Sensor error' on a SATO CG412TT and how do I fix it?
A 'Sensor error' on your SATO Printer can be due to a wrong sensor level, wrong sensor type, too big a value set for pitch offset, or label meandering. Adjust the level, adjust the sensor type, or set a smaller value for the pitch offset.
What to do if my SATO CG412TT labels are not dispensed?
If labels are not dispensed from your SATO Printer: Set dispenser unit correctly Clean the Dispensing roller and Platen roller.
What to do if my SATO Printer shows 'Ribbon near end'?
If your SATO Printer displays 'Ribbon near end', it indicates that there is not much ribbon left. Replace the ribbon to resolve this issue.
What to do if my SATO CG412TT is not feeding media?
To address the issue of your SATO Printer not feeding media: Set media correctly, Set the sensor correctly by Utility Tool setting Check the connection of sensor cable. Adjust sensor level Clean the platen roller.
What to do if my SATO Printer displays 'Ribbon end' error?
If your SATO Printer shows a 'Ribbon end' error, it means that the printer is either out of ribbon or the ribbon is ripped, or the ribbon is not set properly. To fix this, set the ribbon properly.
General| Print Method | Thermal Transfer / Direct Thermal |
|---|---|
| Operating System Compatibility | Windows, Linux |
| Print Resolution | 305 dpi |
| Maximum Print Width | 4.1 inches (104 mm) |
| Maximum Print Length | 999 mm |
| Media Type | Roll |
| Media Width | 0.87 inches (22 mm) to 4.57 inches (116 mm) |
| Media Thickness | 0.06 mm - 0.25 mm |
| Media Roll Diameter | 127 mm (5 inches) |
| Interfaces | USB, Serial, Ethernet |
| Supported Barcode Types | QR Code |
| Power Requirements | AC 100-240V, 50/60 Hz |
| Print Speed | Up to 4 ips (100 mm/sec) |
| Ribbon Width | 1.3 inches (33 mm) to 4.5 inches (114 mm) |
