SATO CL608e - Table of Contents

TABLE OF CONTENTS
SECTION 1. PRINTER OVERVIEW
Introduction .............................1-1
General Printer Specifications ....................1-2
Character Fonts ...........................1-4
Bar Codes ..............................1-5
Physical ...............................1-6
Optional Accessories .........................1-7
SECTION 2. INSTALLATION AND CONFIGURATION
Introduction .............................2-1
Unpacking and Parts Identification .................2-2
Setting Up the Printer ........................2-3
Loading Labels, Tags and Ribbon in the CL608 and CL612e.....2-4
Loading Labels, Tags and Ribbon in the CL408 and CL412e.....2-8
Label Sensor Adjustments, CL608e and CL612e ..........2-11
Label Sensor Adjustments, CL408e and CL412e ..........2-11
Operator Panel, CL608e and CL612e ................2-12
Operator Panel,CL408e and CL412e ................2-14
Rear Panel, CL608e and CL612e ..................2-16
Rear Panel, CL408e and CL412e ..................2-17
Switches and Sensors, CL608e and CL612e ............2-18
Switches and Sensors, CL408e and CL412e ............2-19
SECTION 3. CONFIGURATION
Printer DIP Switch Configuration ..................3-1
Default Settings ...........................3-6
Potentiometer Adjustments .....................3-7
LCD Panel Printer Configuration...................3-9
Normal Mode ..........................3-10
Advanced Mode .........................3-12
Card Mode ...........................3-15
Service Mode ..........................3-18
Counter Mode..........................3-22
Test Print Mode .........................3-22
Default Setting mode ......................3-23
Clear Non-Standard Protocol Codes...............3-24
SATO CL “e” Series Printers PN 9001074 Rev. B Page - iii
Preface