SATO CL6NX - Safety Precautions

CL6NX KITTING MANUAL
Slide
20. Open the Dispenser-unit.
21. Attach (31), fix by (32) screw.
<Note> Refer to below photo.
Set to match Center-line of Dispense-bar
and ▲ mark (of Engine-frame), then fix it by screw.
22. Attach (33), fix by (34) and (35) screw
<Note>A convex protrusion , and placed in a
Front cover under(DS) holes.
23. Close the Dispenser-unit.
24. Attach (36), fix by (37).
Fin (Conversion)
Center line
(31)
DISPENSER BAR
(34)
PAN SCREW SW+WL
(MD3401028): 2pcs
Open
(35)
PAN SCREW SW+WL
(MD4300622): 1pc
(33)
FRONT COVER
UNDER (DS)
(32)
PAN SCREW SW+WL
(MD4300622): 1pc
KIT items
KIT items
KIT items
KIT items
KIT items
Torque : 14.0～16.0 Kg･cm
Torque : 7.0～8.0 Kg･cm
Torque : 7.0～8.0 Kg･cm
(37)
PAN. SCREW SW+WL
(MD4401022)
(36)
COVER LH
Reuse
Reuse
Torque : 14.0～16.0 Kg･cm
Page. 8
Convex put in the hole
Note
DS KIT +RW MODEL
DS KIT MODEL