SATO CL6NX - Page 13

CL6NX KITTING MANUAL
<Check and adjust after assembly Dispenser-kit>
<Test printing method>
(1) Power ON the CL6NX printer (press ｢Power」key)
(2) Clock display confirmation. (DS+RW MODEL only)
(3) Press 「Soft-L」
(4) Press 「Soft-R」, display the “Offline”
(5) Press ｢Enter｣ key, display the “Settings”
(6) Press ｢ or ｣key several times
Change Settings-menu; “Printing”  “Tools”
(7) After select “Tools”, press ｢Enter｣ key x 3-times
(8) After display “Factory”, press ｢Soft-R｣ key.
Printer will be start printing the Factory-test-print.
When you want to stop printing, press ｢Soft-R｣ key again.
Power
Soft-R
//
Soft-L
Back
Enter
Navigation
Page. 11
DS KIT +RW MODEL
DS KIT MODEL
20:30
Clock display
confirmation
DS KIT+RW MODEL only
To suit the user label (user ribbon),
please set the print darkness.