What to do if my SATO SG112-ex Label Maker shows an overheat error?
If your SATO Label Maker displays an 'Overheat error,' it means that the product's temperature has exceeded its tolerance. Stop using the product and allow it to cool down.
What does 'Framing error' mean on my SATO Label Maker?
A 'Framing error' on your SATO Label Maker indicates that the RS-232C settings are incorrect or the RS-232C cable is not connected correctly. Set the interface settings of the product again. If that doesn't work, power off the product, connect the RS-232C cable correctly, and then power it back on.
How to fix parity error on SATO SG112-ex Label Maker?
A 'Parity error' on your SATO Label Maker indicates that the RS-232C settings are incorrect or the RS-232C cable is not connected correctly. Set the interface settings of the product again. If that doesn't work, power off the product, connect the RS-232C cable correctly, and then power it back on.
Why am I getting an overrun error on my SATO SG112-ex Label Maker?
An 'Overrun error' on your SATO Label Maker indicates that the RS-232C settings are incorrect or the RS-232C cable is not connected correctly. Set the interface settings of the product again. If that doesn't work, power off the product, connect the RS-232C cable correctly, and then power it back on.
General| Print Method | Thermal transfer |
|---|---|
| Ribbon Length | 300 m |
| Interfaces | USB, Serial, Ethernet |
| Operating Temperature | 5°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Max Print Width | 104 mm |
| Media Type | Labels, tags |
| Media Width | 25.4 mm to 118 mm |
| Media Thickness | 0.06 mm to 0.18 mm |
| Ribbon Width | 110 mm |
| Processor | 32 bit RISC CPU |
| Power Supply | AC 100-240V, 50/60Hz |
| Print Resolution | 203 dpi |
| Memory | 16 MB |
To Next Page
