SATO WS412DT - MID Cover; Motor

15
4.4 Mid Cover
1. Remove the main board and bottom cover
first
2. Pull the mid cover downward and take out it.
(Figure D-1)
Warning:
 Always turn off printer power before removal.
 Before replacing TPH, please wait for the
printer head temperature to cool.
D-1
4.5 Motor
1. Remove the mid cover of the printer first,
and then cut cable tie which locates the
cable of motor as shown in Figure E-1.
2. Using screwdriver to loosen the 3 screws
from the printer module. (Figure E-2)
3. Take the motor as shown in Figure E-3
Warning:
Always turn off printer power before removal.
Caution:
 When disconnect the power cord, please wait
10 seconds after removing any connectors
from the printer.
 Wait for the motor temperature to cool.
E-1