SATO WS412TT - ESC+GI Store Graphic

215
Memory Card
Available for
WS4 series
ESC+GI Store Graphic
ESC+GI
HEX code
ESC
GI
Parameter
<1B>16
<47>16<49>16
abbbcccdddn~n
Default setting
None
Persistence of the
command
When printer is powered off
Stored data will be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Stores the graphic pattern data.
[Format]
<GI>abbbcccdddn~n
● Parameter
a [Selects and sends Hexadecimal or Binary data] = H : HEX data
B : BIN data
HEX data (8 bits data is divided into 4 bits, and outputs as a HEX code corresponding to ASCII.)
Binary data (Outputs 8 bits as 1 character data is all at once)
b [Specifies the horizontal graphic area in byte] = See the table below
c [Specifies the vertical graphic area in byte] = See the table below
d [Registration number] (identification number to recall) = Valid range: 1 to 999
n [Data] = Graphic data
[Coding example]
<A>
<CC>1
<GI>H003003001n~n
<Z>
[Note]
1. Specify the storage data only.
2. To change the stored content, clear it with the Clear <*> command and store it again.
3. The data stored with this command can be printed with the Recall Graphic <GR> command.
4. If the graphic data is not stored properly, a print error may occur. Refer to the Custom Graphics <G> command for the data form.
5. Attempts to store using a predefined storage number will result in an error and the targeted content will be printed.
6. The Card Slot <CC> command must be sent prior to this command.
[Validity]
Model
Max. bytes in horizontal direction
Max. bytes in vertical direction
WS408DT/TT
104
400
WS412DT/TT
156
600
Store Graphic