Sauder 417714 - Page 10

Step 4
å
Carefully place your MOLDINGS onto the TOPS (G2 and H2).
å
Fasten the MOLDINGS (BBB, DDD, and FFF) to the RIGHT
TOP (G2) and MOLDINGS (CCC, EEE, GGG, and HHH)
to the LEFT TOP (H2). Use twenty-six BLACK 1-1/4" FLAT
HEAD SCREWS (7S).
å
NOTE: Do not overtighten the SCREWS into the TOP.
417714 www.sauder.com/servicesPage 10
HHH
EEE
CCC
GGG
H2
G2
DDD
BBB
FFF
Surface with holes
Surface with holes
The large hole must be here.
The large hole must be here.
BLACK 1-1/4" FLAT HEAD SCREW
(26 used in this step)
7S
Remember:
Righty tighty.
Lefty loosey.
Do not overtighten
the SCREWS (7S).