Sauder 417714 - Keyboard

Step 8
å
Fasten the NARROW EXTENSION RAILS (PPP) to the other surface
of the RIGHT UPRIGHT (E) and KEYBOARD UPRIGHT (VV). Use
four GOLD 5/16" FLAT HEAD SCREWS (3S).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
shown in the enlarged diagram. Then, slide the inner cartridge
of the EXTENSION RAIL in to fi nd the other hole that
lines up with the holes in the UPRIGHTS. Turn a
SCREW into this hole.
KEYBOARD
DRAWER ON RIGHT
E
VV
Surface without
TWIST-LOCK
®
FASTENER holes
PPP
PPP
Narrow
Extension
Rails
Open end
Surface with
TWIST-LOCK®
FASTENERS
Open end
Finished edge
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
3S
417714 www.sauder.com/servicesPage 14