Sauder 417714 - Page 28

Step
å
Insert the dowel end of four TWIST-LOCK® FASTENERS (7F) into
the large holes in the RIGHT TOP (G2) and RIGHT BACK (N).
å
NOTE: If you already pushed TWIST-LOCK® FASTENERS into
the large holes in the RIGHT UPRIGHT (E), pull the FASTENERS
back out of the holes. Pull at the front and back edges, slowly
working the FASTENERS out of the holes.
å
Push the RIGHT UPRIGHT (E) onto the TWIST-LOCK®
FASTENERS (7F) in the RIGHT TOP (G2) and RIGHT BACK (N).
Tighten the TWIST-LOCK® FASTENERS.
Step 22
G2
N
E
Surface without
EXTENSION RAIL
Large hole should be located here.
7F
417714 www.sauder.com/servicesPage 28