NRT405F901 manual Chapter 10 Button management 23
Configuration via the parameter list
The factory settings are changed in the parameter list shown in the display by using the
buttons on the controller.
The parameter values are changed with the INCREASE and DECREASE buttons and
changes confirmed with the On/Off button.
Setpoint limitation
In parameter 34 and 35 it is possible to set the maximum permitted increase as well as
decrease of the setpoint.
Example: If P35=5 and P34=3, the setpoint can be adjusted between 17°C and 25°C (see the
picture below).
To Next Page
Loading...
