Savant Single-Room Pro Remote - Settings; About; Remote Settings

Pro Remote User Guide | 009-1410-06 45 Perseverance Way, Hyannis, MA 02601
© 2020 Savant Systems, Inc | 201210 9 of 18 Savant.com | 508.683.2500
4. Settings
In the Settings screen, a user can view and modify hardware related functions. Adjusting sleep timers, screen brightness and viewing version information
are a few of the actions available.
4.1. About
The About screen gives specific version and FCC information about the Pro Remote.
Name The name of the Pro Remote as configured by the Savant Integrator in Racepoint Blueprint.
UID
The Savant Unique ID of the Pro Remote. Used for custom button programming by the Savant
Integrator.
Model Model number of the Pro Remote is displayed.
Version Version of the software loaded on the Pro Remote.
S/N Serial number of the Pro Remote.
FCC/ID and IC Regulatory Information for the Pro Remote.
Send Diagnostics
When troubleshooting a problem, the Savant Support Team may require the embedded logs from
the Remote. Pressing the Send Diagnostics field will upload the log files to the Savant Host. Full
communications between the Remote, Remote Base, and Host are required. With the log files
loaded in the Host, the Savant Support Team can view the files and take any necessary actions
required.
4.2. Remote Settings
All settings available in the Remote Settings screen and their meanings.
Power Button
Single press instantly powers o the room and Services. Two-Step requires confirmation of power
o commands.
Sleep
Sets the amount of time the Remote will stay active without moving or pressing a button before
going to sleep or into power saver mode. Tap to access the Sleep Adjustments screen. Select the
time for the remote to stay active. The selections range from 10 seconds to 2 minutes. Shorter
times may extend battery life.
Brightness
There are five levels of intensity to choose from. Set the brightness level by selecting more of
fewer dots. Selecting more dots indicate a brighter screen. Fewer dots may extend battery life.
Wake Sensitivity
The amount of movement required to wake up the Remote after it has gone to Sleep. Tap to
access the Wake Sensitivity field. In the Wake Sensitivity adjustment screen, select Low, Medium
or High. A setting of High will require less movement of the Remote to wake it up.
Wi-Fi Information
Network Displays the name of the SSID.
IP Address Provides the IP Address of the Remote
Strength
Wi-Fi single strength displays in a fraction out of 4 and the measured db
strength.
Channel SSID channel with the frequency.
Frequency Shows the frequency band that the Remote is assigned to.
Configure Wi-Fi Reconfigures, or resets the Wi-Fi information and the saved SSID.
ABOUT
Battery
100%
UID: 001AE12345678901
Model
REM-4000xx
Version 9.3.0
S/N
QRN00000000
FCC/ID: AUS-SUR2000
IC: 10052A-SUR2000
Remote Control
Power Button
Sleep
Brightness
Wake Sensitivity
REMOTE SETTINGS
Wi-Fi Information
Factory Reset