SBE SB-36 - Page 16

SBE SB-36 OPERATION MANUAL
30 DELAY Control Potentiometer that varies the resistance in a time constant
circuit on the audio board. When using VOX keying in the
transmit mode, its function is to adjust the length of time that
the transmitter stays keyed after the operator stops
speaking.
31 ANTI- TRIP Control The potentiometer that varies the attenuation of the speaker
audio signal being applied to the ANTI-VOX amplifier circuit
input. Its function is to adjust the threshold level of the
modulated audio that keeps the SB-36 keyed for a receive
condition.
32 Phone Patch
"IN JACK"
A connector which will accept phone patch information to
excite the transmitter.
33 Phone Patch
"OUT JACK"
A connector which provides a 600 ohm audio output for use
with phone patch devices.
34 Antenna Jack The SO-239 connector for connecting the antenna to both
transmitter output and receiver input.
35 VFO Jack A 7-pin socket to be used in conjunction with the external
VFO accessory. When the external VFO is not used, the
dummy VFO plug should be installed in this
socket.
36 Ext. ALC Jack A connector for accepting external ALC information from a
companion linear amplifier to control the transmitter output.
37 RF Jack This jack provides a low-level output for use with a
transverter.
38 REM Jack This jack provides a remote output to control a companion
linear amplifier. The remote output jack
provides a ground connection when the transceiver is in the
transmit mode.
39 SP Jack A connector providing an audio output for external speaker
use.
40 POWER connector An 11-pin plug providing primary and secondary power input
connections from the accessory power supply.
41 GROUND Connector A threaded bolt with wing nut provided for earth ground
connections.
NoobowSystems Lab. Tomioka, Japan 2003 http://www.noobowsystems.com/ Page 16 / 56