EasyManua.ls Logo

SCAC STS60-23BV - Maintenance Considerations & Storage

Default Icon
85 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
R
Section 2
TIE DOWN
POINT
TIE DOWN
POINT
Figure 2-2. Front Tie Down Points
TIE DOWN
POINT
TIE DOWN
POINT
Figure 2-3. Rear Tie Down Points
27. Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure vision.
28. NEVER leave the machine running unattended.
29. Always wash your hands or exposed areas after
contact with chemicals.
30. If a chemical spill occurs, make sure to refer to the
chemical manufacturer's recommendations for clean
up / neutralization.
31. When changing chemicals, always make sure to
rinse the system thoroughly, following the chemical
manufacturer's instructions for neutralizing the
chemical.
2.6 MAINTENANCE CONSIDERATIONS &
STORAGE
1. Never make adjustments to the machine with the
engine running unless specifically instructed to do
so. If the engine is running, keep hands, feet, and
clothing away from moving parts.
2. Place the control levers in the neutral position,
engage the parking brake, stop engine and remove
key or disconnect spark plug wire(s) to prevent
accidental starting of the engine when servicing or
adjusting the machine. Wait for all movement to stop
before adjusting, cleaning or repairing.
3. Remove spark plug wire(s) before making any
repairs.
4. Keep all nuts, bolts and screws tight, to ensure the
machine is in safe working condition. Check spray
nozzles and hoses frequently to be sure they are
tight.
5. Do not change the engine governor settings or
overspeed the engine. See the engine operator's
manual for information on engine settings.
6. To reduce fire hazard, keep drives, muffler, and
engine free of grass, leaves, excessive grease, oil
and dirt.
7. Park the machine on level ground.
8. NEVER allow untrained personnel to service the
machine.
9. Use care when checking the sprayer/spreader
system, make sure to use proper protective
equipment when working with areas that are
exposed to chemicals.
10. Keep all parts in good working condition. Replace all
worn or damaged decals.
11. Use jack stands to support components when
required.
12. Carefully release pressure from components with
stored energy.
WARNING
The spray system traps liquid under high
pressure, even when the engine is off. High
pressure discharge could cause serious injury
or death.

Table of Contents