OPM 320 en-GB 4
© Scania CV AB 2019, Sweden
Introduction
Introduction
This Operator's manual describes the operation
and maintenance of Scania industrial engines.
The engines are liquid-cooled Otto gas engines
with turbochargers.
The engines are available with different power
settings. Engine power for the engine ordered is
indicated on a plate located on the engine control
unit.
Only standard components are described in the
operator's manual. Information about special
equipment is contained in instructions from the
various manufacturers.
To ensure the maximum performance and the
longest service life for the engine remember the
following:
• Read through the Operator's manual before
starting to use the engine. Even regular users
of Scania engines will get new information
from the Operator's manual.
• Always follow the maintenance instructions.
• Read the section on safety carefully.
• Get to know your engine so that you know
what it can do and how it works.
• Always contact an authorised Scania work-
shop for maintenance and repairs.
The information in this Operator's manual was
correct at the time of going to press. Scania re-
serves the right to make alterations without prior
notice.
Always use spare parts that are approved by Sca-
nia for maintenance and repairs.
To Next Page
Loading...
Need help?
General
