Power classes
OPM 320 en-GB 5
© Scania CV AB 2019, Sweden
Power classes
Scania supplies engines in two different power classes:
PRP, Prime power: Intended for continuous use and an unlimited number of operational hours with vary-
ing loads. The average load factor must not exceed 70% of the rated power in a 24-hour period. Accumu-
lated overload 110% for one hour per 12-hour period. This power class applies to single-speed engines.
COP, Continuous power: Intended for continual use with a non-varying load and an unlimited number of
operational hours.
The engine serial numbers and power classes for the engines that are used in this installation should be listed
below: You can find the power class of your engine in the engine type data sheet on the Scania website,
www.scania.com.
Engine serial no.:
Engine type:
Engine power: kW at rpm
PRP, Prime power
COP, Continuous power
To Next Page
Loading...
