Scanreco RC400 User Manual

Installation instructions 4 - 8
Doc.nr : 6611-018
&RQQHFWLRQRIPRWRUVWDUWVWDUWORFN

• To protect the starter motor against unintentional re-start attempts after the vehicle motor
has already started, it is recommended that an electric "start lock" is connected in after the
motor start signal from the electronicbox, EX cable pin  ( See connection example
below ).
• To be able to find out if the vehicle motor is already started, a signal can be taken, for
example, from the generator. In this way the crane driver cannot
activate the starter motor
by mistake.
• Before connection, consult the truck manufacturer, customer and inspector !

6WDUWORFN3URWHFWLRQUHOD\+HOSUHOD\
'HVFULSWLRQRIVWDUWORFN([DPSOH6WDQGDUGFDUUHOD\W\SH%RVFK

• :KHQDQLPSXOVHLVUHFHLYHGIURPWKHSRUWDEOHFRQWUROXQLW9'&LVJHQHUDWHG(;QRYLDWKHVWDUW
ORFNUHOD\WRWKHVWDUWHUPRWRU:KHQWKHPRWRUKDVVWDUWHGWKHVWDUWORFNUHOD\UHFHLYHVDYROWDJHRQSLQ
IURPWKHJHQHUDWRUDQGWKHUHOD\LVSXOOHG
• ,IDQHZDFWLYDWLRQLVPDGHDQGDQLPSXOVHLVJHQHUDWHGIURPWKHSRUWDEOHFRQWUROXQLWWKHYROWDJHZLOOQRW
UHDFKWKHVWDUWHUPRWRUVLQFHWKHVWDUWORFNUHOD\LVDFWLYDWHGLHDVWDUWQRQUHSHDWORFN
• *HQHUDWRUFRQQHFWLRQ'7KLVLVRQO\DQH[DPSOH%HIRUHFRQQHFWLQJFRQWDFWWKHWUXFNPDQXIDFWXUHU



)O\LQJ-LE([WHQGLQJMLE
During the manoeuvring of for example a jib / tool or reversing valve from the control unit the
manual switch / breaker must always be activated. This is so that manual manoeuvring can be
made if any fault should occur in the remote control system.
hydrostat.ru

Scanreco RC400 Specifications

General

Category	Remote Control
Model	RC400
Operating Temperature	-20°C to +55°C
Power Source	Battery
Protection Class	IP65