Installation instructions 4 - 10
Doc.nr : 6611-018
%$77(5<&+$5*(5$1'%$77(5<&+$5*,1*
The battery charger must
be mounted in a vibration free location inside the cab or indoors to
give protection against damp and temperature variations.
• The normal charge time for an empty discharged battery is approx. 12-14 hours.
• The battery charger should be connected directly to the vehicle’s battery to enable idle time
to be utilised for charging.
• The battery charger is constructed so that the battery packs will not be damaged by long
continuous charging.
• The supply voltage for the battery charger should be +11 VDC to +30 VDC.
7KHUHDUHWZROLJKWHPLWWLQJGLRGHV/('VRQWKHEDWWHU\FKDUJHU
x $5('/(' (32:(5) : indicates supply voltage present ( i.e. from the vehicle battery ).
x $*5((1/(' (&+$5*,1*) : indicates that charging is taking place.
A fuse-holder ( bayonet type ) is located next to the power cable with a glass fuse
3 Amp. ( quick ), with size 5 x 20 mm.
3RODULW\IRUFRQQHFWLRQFDEOH%OXHDQG%URZQ
%DWWHU\FKDUJHUFXUUHQWZLWKRXW
EDWWHU\SDFNLV
≈
P$
%DWWHU\FKDUJHUFXUUHQWZLWK
EDWWHU\SDFNLV
≈
P$
7HUPLQDOYROWDJHDWEDWWHU\FKDUJHUWHUPLQDOVLVDSSUR[LPDWHO\WKHVDPHDVWKHYHKLFOHVXSSO\YROWDJH
:LWKGHIHFWLYHQRQIXQFWLRQLQJEDWWHU\FKDUJHU
If the driver is using cable control and the battery pack is located in the control unit, the
battery will be charged automatically. See also below.
%DWWHU\FKDUJLQJYLDFDEOHFRQWUROHJRYHUQLJKW (&KDUJLQJWLPHLVDSSUR[ KRXUV).
Place the battery pack into the control unit (HPHUJHQF\VWRSGHSUHVVHG) and connect the cable
between the control unit and the electronicbox (FUDQHVHPHUJHQF\VWRSWZLVWHGXS
The electronicbox in 5HPRWH : (3RZHU, and LED 1R should blink). Battery charging is now taking
place !
To Next Page
Loading...
Need help?
General
