EasyManuals Logo

Scanreco RC400 User Manual

Scanreco RC400
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
General system description 2 - 4
Doc.nr : 6611-018
3RUWDEOHFRQWUROXQLWZLWK
EDWWHU\RSHUDWLRQUDGLRFRQWURORURSWRILEUHFDEOH
A battery is located in the control unit for radio control and is very simple to change.
The batterys effective operation time is about 8 hours on one charge.
When the battery is approaching time for charging, the control unit beeps three ( 3 ) times
as a warning and at the same time the LED starts to blink on the control unit.
The battery mustbe used until the LED goes out, after which it can be changed.
If the battery capacity is too LOW the control unit cannot be activated.
The battery capacity and operational performance is reduced in extremely cold conditions.
( The battery is automatically charged during operation by cable control ).
In order to reduce battery loading and for safety reasons, the control unit is turned off
automatically, after the unit has been idle for more than approximately five ( 5 ) minutes.
hydrostat.ru

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Scanreco RC400 and is the answer not in the manual?

Scanreco RC400 Specifications

General IconGeneral
CategoryRemote Control
ModelRC400
Operating Temperature-20°C to +55°C
Power SourceBattery
Protection ClassIP65

Related product manuals