Scansonic D100 - Sw Version; Sleep Button

11
SW version
1. Press “Select” key you can see the software version directly
Note: To exit setup, press ‘MENU’ button.
Sleep Button
It allows you to set the sleep time
1. Press ‘Sleep’ button on your remote control, the following screen will be
displayed:
2. You can select the desired period of the sleep function by repeatedly
pressing the “Sleep” button on the remote control until the desired
period is displayed. You can choose between 15 minutes, 30 minutes,
60 minutes, 90 minutes or OFF. Press the “Select” button on the remote
controltoconrmyourchoice.Theradiowillnowautomaticallyshut
down after your chosen period of time.
3. If you wish to cancel the preselected sleep function, use the steps above
andchoose“OFF”,thenpress“Select”onyourremotecontroltoconrm.