ScanSpeed Mini - Page 12

Model Mini Centrifuge
04032013RS01
Cat. No. 9.900.900.730
CopyRight © 2013
Page 12 of 16
Error
Code
Problem
Possible Reason

E1
RPM Sensor Error:
Corrective Action
Turn the power switch off and back on to reset.
Failure to reach to 200 rpm
within 2 sec.
If problem cannot be resolved, it is possible that


Call LaboGene for Service
 by the emergency door open function
Door Open Error:

E2
Door opens during operation
Corrective Action
Close the door and turn the power switch off and back on to
reset.
If problem cannot be resolved, it is possible that

Call LaboGene for Service

E3
Motor Overheated:
Detected internal temperature is
higher than 110
Corrective Action
1. Clean the ventilation inlet opening or remove any objects are
blocking the vent.
2. Tun the power switch off and wait approximately 1 hour with
the door open to cool down the motor.
3. Turn the power switch back on to reset.

Corrective Action
Turn the power switch off and back on to reset.
If problem cannot be resolved, it is possible that
amaged.
Call LaboGene for Service
Undervoltage

E4
Corrective Action
Use Automatic Voltage Regulator to provide proper voltage.
Overvoltage
tion allows
E5
Corrective Action
Use Automatic Voltage Regulator to provide proper voltage.