To Next Page
V
Valerie BraunAug 20, 2025
What to do if I get an RPM Sensor Error on my ScanSpeed Laboratory Equipment?
- DdanielsrichardAug 20, 2025
If you encounter an RPM Sensor Error with your ScanSpeed Laboratory Equipment, first, turn off the power. Then, carefully inspect the RPM sensor and its cable for any visible damage or loose connections. After checking, power the equipment back on to see if the error has been resolved. If the problem persists, it may be necessary to replace the RPM sensor assembly, as the sensor itself might be defective, the motor could be out of order, or the cable is not connected properly.
General