The drilling machine is now ready for use. Start the machine by pressing the green button
switch on the left-hand side. When the motor is started press the spindle head down by
turning the large handle on the right-hand side of the machine. Stop the machine again by
pressing the red OFF button on the side of the machine.
In addition to the spindle speed table, the emergency stop is also placed on the front cover,
together with a scale measuring the drilling depth. The arrow can be moved up and down on
the scale according to your wishes.
The drilling machine is equipped with an automatic drill launcher (8) (see fig. 2.1), This
functions by turning the pawl below the left hand side, now the drill chuck can run into the
drill house and at the same time the drill will be launched.
Cross Table
The adjustment of the cross table takes place by the two handles which are placed in front of,
and on the side of the cross table.
Automatic Feed
NOTICE: THE AUTOMATIC FEED DOESN’T WORK WHEN RUNNING COUNTER CLOCK-WISE! –
Clicking sound will appear in Automatic Feed.
The adjustment of the feed speed takes place on the right-hand side of the drilling machine.
There are four different speeds to choose between, below is stated which feed the four steps
corresponds to.
To Next Page
Loading...