5. Transport & Handling
Transport
Scantool SB 30 and 40 drilling machines are delivered in a wooden container with the
following measures:
800 x 545 x 2005
and packed in protective wood packing.
Handling
The machine can easily be transported in the wooden box, in which it is delivered.
Placing
Release the machine from the packing. Placing must take place on a firm and level ground.
The machine must be fastened to the ground by means of the four fittings which are in the
base.
The drilling machine is provided with no-volt release protection switch.
The electrical connection must be performed by an authorized electrician, and the machine
must be protected with a 16A fuse. It is important to check, that the motor has the correct
direction or rotation.
The machine is now ready for use. It is recommended to read this manual very carefully
before use.
To Next Page
Loading...