Scantronic 4602 - User Manual

496368 Issue 1 1 of 12
4600
Installation and User Guide
Compatible Equipment
4601 Long range and short range pendant transmitters
4602 Hand held PA
4603 Programmable transmitter
4604 Contact transmitter
4605 Short range dual channel transmitter
4608 PIR
4609 Smoke detector
7150 Viper radio vibration detector (supplied by Weyrad Elec-
tronics).

Summary

Compatible Equipment List

4601 Pendant Transmitters

Lists compatible long and short range pendant transmitters.

4602 Hand Held PA

Lists compatible hand-held Personal Attack transmitters.

4603 Programmable Transmitter

Lists compatible programmable transmitters.

4604 Contact Transmitter

Lists compatible contact transmitters.

4605 Dual Channel Transmitter

Lists compatible short range dual channel transmitters.

4608 PIR Detector

Lists compatible Passive Infrared (PIR) detectors.

4609 Smoke Detector

Lists compatible smoke detectors.

7150 Viper Vibration Detector

Lists the Viper radio vibration detector.

System Introduction

Overview of the 4600 System

Overview of the 4600 electronic intruder alarm system's capabilities and design.

Technical Specifications

Electrical and Environmental Parameters

Details electrical input, protection, battery backup, auxiliary output, dimensions, weight, humidity, and operating temperature.

Wiring Diagrams and Connections

External SAB Bell;Strobe and Speaker Connections

Illustrates external SAB Bell/Strobe and internal speaker connections.

Programming Detectors Overview

Detector Site Code Setup

Explains setting a site code using DIL switches for system identification and avoiding interference.

Initial Power-Up and Configuration Steps

Setting the Site Code

Guides on setting the site code via DIL switches on the control panel.

Entering Programming Mode

Provides steps to access the system's programming mode using access codes.

Programming Commands and Defaults

Command Entry Procedure

Details how to input commands and corresponding values for system configuration.

Factory Default Settings

Lists the default engineering access and user codes for the system.

Engineer Programming: Access, Timers, and Zones

Access Code, Jamming, and Timer Settings

Configures engineer access code, jamming, and timers like exit and bell duration.

Zone Type and System Mode Settings

Sets zone types (Entry/Exit, PIR) and system modes like Instant Night Mode.

Engineer Programming: Zone Options and System Tests

Zone Options Configuration

Details setting specific options for each zone.

System Testing and Defaults Loading

Covers system tests, jamming detection, and loading factory defaults.

Exiting Programming and Factory Resets

Leaving Programming Mode

Instructions for exiting programming mode after configuration is complete.

Restoring Factory Defaults

Steps to reset the system to its original factory settings.

System Testing Procedures

Walk Test Guide

Guides on performing a walk test to verify zone operation and system functionality.

Fault Finding - Initial LED Displays

Interpreting Fault Displays (Figure 4)

Explains how to interpret LED indicators for common fault and alarm conditions as shown in Figure 4.

Fault Finding - Extended LED Displays

Interpreting Fault Displays (Figure 5)

Provides further LED indicator interpretations for remote transmitter faults and power status as shown in Figure 5.

User Command Reference

Keypad Operations and Commands

Lists user commands for system arming, disarming, and configuration via keypad.

Remote Setting Device Operations

Details commands for system arming, disarming, and PA activation using the remote device.

Scantronic 4602 Specifications

General

Power Supply	230VAC
Dimensions	250 x 210 x 80mm
Zones	8
Wireless	No
Detection Range	N/A (Wired System)
Mounting Height	N/A (Depends on detectors used)
Part Set Suites	2