Schaerer Coffee Art

www.schaerer.com
31
BASCA - EN
Version 06 01.2010
2 x delay pre-infuse
1.0 s.
Appears only if the parameter dispensing mode is programmed to “double product”!
Parameter can only be changed by a qualified service technician! ►
2 x chamber opening time
0 ms
Appears only if the parameter dispensing mode is programmed to “double product”!
Parameter can only be changed by a qualified service technician! ►
2 x wet pressing
no
Appears only if the parameter dispensing mode is programmed to “double product”!
Parameter can only be changed by a qualified service technician! ►
product buttons
product buttons
► To access a menu, see “Programming overview: CHEF card”, page 23
select product
< press button >
BB
Select the desired product (for which the parameters are to be set) ►
select product
cappuccino
The product type can only be changed by a qualified service technician! ►
counted products
01
Parameter can only be changed by a qualified service technician! ►
output sequence
milk before coffee
Parameter can only be changed by a qualified service technician! ►
prod. preselection
yes
Parameter can only be changed by a qualified service technician! ►
dispensing mode
single product
Parameter can only be changed by a qualified service technician! ►
product test
restart required
Product can only be tested by a qualified service technician! ►
Product buttons: Products with milk