Instruction Man u al Instrument Panels IT 96-A, IT 96-2
11
Issued: 26.11.2007
830.636 BA / EN
Fault RemedyPossible cause
The ”Check mains” LED
(yellow) does not light up
No power coming from the
mains supply.
Check mains connections
(e.g. camping site).
even though it is
connected up to the
230 V power supply.
The power cutout to the
electrobloc has tripped or
is switched off.
Reset the power cutout.
5.7 Switching off
"
Briefly press the left key in the middle control panel (12V -- 0).
The green indicator LED extinguishes.
The 12 V power supply in the living area is now switched off.
Exceptions:
F
Heater
F
Power circuit reserve 4
F
Floor light/step
F
Compressor/AES refrigerator
These consumers are always at stand-by even with the 12 V power supply
switched off.
5.8 Closing down the system
Switch off the system if you are not going to use the vehicle for a lengthy
period (for example during the winter).
"
Disconnecting the leisure battery from the 12 V power supply (remove
battery poles).
"
More detailed information on cl osing down the system can be found in
the EBL ... electrobloc instruction manual.
6 Mainten an ce
The instrument panel IT 96 A / IT 96-2 requires no maintenance
Clean the front plate using a soft, moist cloth and mild detergent. Never use
spirit, thinners or similar substances. Do not allow fluid to penetrate the in-
side of the instrument panel.
The reproduction, translation and duplication of this manual, even in parts, is
not allowed without written authorisation.
Cleaning
E