Instruction Man u al Instrument Panels IT 96-A, IT 96-2
7
Issued: 26.11.2007
830.636 BA / EN
Y
To start these consumers for the first time after the elctrobloc had been
switched off by the battery disconnecting switch or by a battery monitor
or after a change in the battery or the connection of the leisure battery
after a long break, the 12 V main switch at the instrument panel must be
briefly switched on.
"
Briefly press the left button in the middle control panel (12V -- 0).
The green indicator LED lights up.
The 12 V power supply in the living area is now switched on.
5.5 Checking the measured values
5.5.1 Battery voltages
"
Briefly press the left button in the left control panel (vehicle symbol).
The battery voltage of the starter battery is shown (the upper scale is appli-
cable).
"
Briefly press the right button in the left control panel (vehicle symbol).
The battery voltage of the leisure battery is shown (the upper scale is appli-
cable).
While the button is pressed, the display instrument lights up and the corres-
ponding measured value is shown.
To Next Page
Loading...
