ww w.scheppach.com
28
|
GB
13. Troubleshooting
Problem Possible Cause Action
Motor doesn’t start a) ON/OFF switch damaged.
b) ON/OFF cable damaged.
c) ON/OFF relay damaged.
d) Fuse blown.
e) Motor burnt.
a-d) Replace all damaged parts be-
fore you use your machine again.
e) Contact your local service centre.
Every attempt to carry out a repair,
can be dangerous if it is not done by
skilled personnel.
Machine gets slower during
work.
Too much pressure put on the workpiece. Reduce the pressure on the work-
piece.
Sanding belt comes o the
drive pulleys.
Belt does not run straight. Reset the track.
The wood gets burnt during
sanding.
a) Sanding disc or belt covered with
grease.
b) Excessive pressure on workpiece.
a)Replace disc or belt.
b) Reduce pressure on workpiece.
To Next Page
Loading...
Need help?
General
