www.scheppach.com
32
|
GB
18. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
Motor does not start On/o switch damaged Replace all damaged parts before you use your sander
again.
Contact your local service centre or an authorised
service station. Every attempt to carry out a repair, can
be dangerous if it is not done by skilled personnel.
On/o cable damaged
On/o relay damaged
Machine becomes
slower during work.
Too much pressure is
applied to the workpiece.
Apply less pressure to the workpiece.
Sanding belt comes
o the drive pulleys.
It does not run straight. Reset the track.
Wood gets burnt
during sanding.
Sanding disc or belt is
covered with grease.
Replace belt or disc.
Excessive pressure was
applied to the workpiece.
Reduce the pressure applied to the workpiece.
To Next Page
Loading...
Need help?
General
