What to do if the engine (230V) of my Scheppach Log Splitter does not start?
If the 230V engine of your Scheppach Log Splitter doesn't start, it might be due to low temperatures causing a high starting current and tripping the circuit breaker. Ensure the temperature is between 5°C and 10°C when starting the motor. Also, use a 16A slow-blow circuit breaker at the mains power connection.
Why does the column of my Scheppach Compact 8t Log Splitter not move downwards even though the engine (400V) starts?
If the engine of your 400V Scheppach Log Splitter starts, but the column doesn't move downwards, the motor might be rotating in the wrong direction. Check and change the direction of rotation of the engine to resolve this issue.
What to do if the column on my Scheppach Compact 8t does not move downwards?
If the column of your Scheppach Log Splitter isn't moving downwards, here are a few things to check: * **Oil Level:** Low oil level can prevent movement. Check the oil level and top it up if necessary. * **Lever Connections:** Ensure all levers are properly connected and fastened. * **Rails:** Dirt on the rails can impede movement. Clean the column thoroughly.
How to troubleshoot a Scheppach Compact 8t Log Splitter when the hydraulic pump does not start?
If the hydraulic pump on your Scheppach Log Splitter isn't starting, there are a couple of things you should check: * **Power Supply:** Verify that the lines have a proper power supply. * **Thermal Switch:** If the motor's thermal switch has been tripped, turn it back on. You'll find the thermal switch inside the motor housing.
Why is my Scheppach Log Splitter not splitting logs?
Your Scheppach Log Splitter might not be splitting logs due to several reasons. Make sure the log is inserted correctly. Another reason might be that the splitting wedge is blunt and needs grinding. Also, check for oil leaks, and if you find any, contact your dealer.
What to do if Scheppach Compact 8t has oil leakage?
If you notice oil leakage in your Scheppach Log Splitter, it could be due to trapped air in the hydraulic system. Try loosening the bleed screw two turns before use. Ensure the bleed screw is tightened before transport. Also, verify that the oil drain screw is firmly tightened. If the oil valve and/or seals are defective, contact your dealer.
Why does the splitting column move down slowly on my Scheppach Log Splitter?
If the splitting column on your Scheppach Log Splitter is moving down slowly, it could be due to a few reasons. First, check the oil level using the oil dipstick, ensuring it's screwed in. Also, make sure the bleed screw is loosened two turns before use. Finally, check if the cap nut of the stroke setting bar is loose; tighten it, and if necessary, replace it.
What to do if Scheppach Compact 8t Log Splitter splitting column vibrates and makes noise?
If the splitting column on your Scheppach Log Splitter vibrates and makes noise, it may be due to low oil and excess air in the system. Check the oil level and top it up if necessary. Otherwise, contact the dealer.
Why is the hydraulic pump whistling on my Scheppach Compact 8t Log Splitter?
The hydraulic pump on your Scheppach Log Splitter might be whistling because there is too little hydraulic oil in the tank. Top up the hydraulic oil.
General| Brand | Scheppach |
|---|---|
| Model | Compact 8t |
| Category | Log Splitter |
| Language | English |
To Next Page
