To Next PageTo Next PageWhat to do if the Scheppach Compact 8t Log Splitter doesn't split the log?
If the log is not split by the Scheppach Log Splitter, ensure the log is inserted correctly. Also, the splitting wedge may be blunt and require grinding. If there are oil leaks, locate the leak and contact the dealer.
Why does the column of my Scheppach Compact 8t Log Splitter not move downwards even though the engine (400V) starts?
If the engine of your 400V Scheppach Log Splitter starts, but the column doesn't move downwards, the motor might be rotating in the wrong direction. Check and change the direction of rotation of the engine to resolve this issue.
What to do if the column on my Scheppach Compact 8t does not move downwards?
If the column of your Scheppach Log Splitter isn't moving downwards, here are a few things to check: * **Oil Level:** Low oil level can prevent movement. Check the oil level and top it up if necessary. * **Lever Connections:** Ensure all levers are properly connected and fastened. * **Rails:** Dirt on the rails can impede movement. Clean the column thoroughly.
How to troubleshoot a Scheppach Compact 8t Log Splitter when the hydraulic pump does not start?
If the hydraulic pump on your Scheppach Log Splitter isn't starting, there are a couple of things you should check: * **Power Supply:** Verify that the lines have a proper power supply. * **Thermal Switch:** If the motor's thermal switch has been tripped, turn it back on. You'll find the thermal switch inside the motor housing.
Why is my Scheppach Log Splitter not splitting logs?
Your Scheppach Log Splitter might not be splitting logs due to several reasons. Make sure the log is inserted correctly. Another reason might be that the splitting wedge is blunt and needs grinding. Also, check for oil leaks, and if you find any, contact your dealer.
What to do if Scheppach Compact 8t has oil leakage?
If you notice oil leakage in your Scheppach Log Splitter, it could be due to trapped air in the hydraulic system. Try loosening the bleed screw two turns before use. Ensure the bleed screw is tightened before transport. Also, verify that the oil drain screw is firmly tightened. If the oil valve and/or seals are defective, contact your dealer.
Why does the splitting column on my Scheppach Compact 8t vibrate strongly in the upper position?
If the splitting column of the Scheppach Log Splitter vibrates strongly in the upper position, the plastic guides are worn out. Replace the plastic guides at the top and bottom.
Why is the splitting column on my Scheppach Compact 8t Log Splitter moving down slowly?
If the Scheppach Log Splitter's splitting column moves down slowly, check the oil level using the oil dipstick with it screwed in to ensure there is enough oil. Also, make sure the bleed screw is loosened two turns before use. Verify that the cap nut of the stroke setting bar is not loose; tighten it, and replace it if needed.
What to do if the motor ends the splitting process automatically on Scheppach Compact 8t?
If the motor on your Scheppach Log Splitter ends the splitting process automatically, the overvoltage protective device might have been triggered. Call a qualified electrician.
What causes the splitting column to vibrate strongly in the upper position on my Scheppach Compact 8t?
If the splitting column on your Scheppach Log Splitter vibrates strongly in the upper position, it is likely that the plastic guides are worn out. Replace the plastic guides at the top and bottom.
General| Brand | Scheppach |
|---|---|
| Model | Compact 8t |
| Category | Log Splitter |
| Language | English |
