www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
27
Oil change (g. 15 - 19)
1. Move the log splitter into the start position and pull
out the mains plug.
2.
3. Turn the log splitter on the support leg side as
Dis
4. machine on the motor side as shown in
5.
screw it back in to the machine that is still in a
6. Now screw the oil drain screw with dipstick back
splitting log several times.
7. Check the oil level one last time and top up with a
little oil if required.
Dispose of the used oil in a correct manner at a
public collection facility. It is prohibited to drop
old oil on the ground or to mix it with waste.
Connections and repairs
Please provide the following information in the event
•
•
•
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol
lowing parts are therefore also required for use as
consumables.
splitting wedge
16. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
AC motor 230 V/ 50 Hz
Mains voltage 230 Volt / 50 Hz.
tion of 1.5 mm².
12. Cleaning
Attention!
ing work on the equipment.
some soft soap. Do not use cleaning agents or sol
the equipment. Ensure that no water can get into the
interior of the equipment.
13. Transport
transport. The machine can be transported on the
14. Storage
The optimum storage temperature is between 5 and
Cover the electrical tool in order to protect it from
dust and moisture.Store the operating manual with
the electrical tool.
15. Maintenance
Attention!
tenance work on the equipment.
We recommend:
• The splitting wedge is a wearing part that needs to
be sharpened or replaced after wear.
• The combined gripping and controlling device must
remain smooth running. Lubricate with a few drops
• Keep splitting wedge drive clean of dirt, wood shav
ings, bark, etc.
• Lubricate slide rails with grease.
When must the oil be changed?
Change the oil after 150 working hours.
To Next Page
Loading...
Need help?
General
