www.scheppach.com
22
|
GB
Functional test
Action: Result:
Push both handles
towards below.
Splitting knife goes down
to approx. 10 cm above the
table.
Let one handle loose,
then the other.
Splitting knife stops in the
desired position.
Let both handles
loose.
Splitting knife returns to
upper position.
Check the oil level before every use – see chap-
ter “Maintenance“.
Venting (g. 14)
•
the air can escape from the oil tank.
• Leave the cap open during the operation.
•
will damage the gaskets and with it the complete log
splitter.
Stroke limit for short logs (g. 10)
Lower splitting knife position about 10 cm above ta
ble.
•
•
•
•
•
•
•
• Switch motor on
• Check upper position
Switching on and o (12)
Press the green button for switching on.
Note: Check the function of the ON/OFF unit before
Restarting safety in case of current interruption
(no-volt release).
For switching on again, press anew the green button
of the switch unit.
9.2 Fitting the table (5)
•
•
•
9.3 Fitting the complete control arms (10)
(accessories bag B)
The control handles on the arms point outwards!
•
• Grease the top and bottom plates.
•
•
•
• Now fasten the other control arm on the other side
in accordance with the method described
9.4 Fitting the claws
(enclosed accessories bag C)
•
• Place the adjustable claws on the hexagon nuts
• Note that the prongs on the claws must point to
m IMPORTANT!
You must fully assemble the appliance before
using it for the rst time!
10. Initial operation
•
•
•
•
• The oil level.
Checking the oil level (g. 13)
the oil pump. The oil level must be within the centre
mark on the oil dipstick. The splitting column must
be retracted before the check, the machine must be
oil level.
To Next Page
Loading...
Need help?
General
