www.scheppach.com
GB
|
23
• Places where the connection cables have been cut
due to being driven over.
•
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
tion damage.
Check the electrical connection cables for damage
not hang on the power network during the inspection.
nection cables with the marking „“.
Three-phase motor 400 V~ / 50 Hz
Mains voltage 400 V~ / 50 Hz
Extension cables up to 25m long must have a
Turn pole inverter in the machine socket.
12. Cleaning
Attention!
ing work on the equipment.
with a cloth.
some soft soap. Do not use cleaning agents or sol
the equipment. Ensure that no water can get into the
interior of the equipment.
13. Transport
B on the splitting column until the machine is inclined
Splitting
• Place the log on the table, hold it with both handles,
press the handles down. As soon as the splitting
knife enters the wood, push the handles down and
to the outside at the same time. This prevents the
wood from putting pressure on the holder plates.
•
• Split the logs in vertical position.
• Never split in horizontal position or across.
•
Attention!
as splitting support or splitting table.
End of work
•
•
•
• Close the venting cap.
• Observe the general maintenance instructions.
11. Electrical connection
for operation. The connection complies with the ap
The customer‘s mains connection as well as the ex
ulations.
•
nection points: This means that use of the product
allowed.
•
•
tion points that
a. do not exceed a maximum permissible mains im
b.
the mains of at least 100 A per phase.
•
ate the product meets one of the two requirements,
Damaged electrical connection cable
The insulation on electrical connection cables is of
ten damaged.
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been im
To Next Page
Loading...
Need help?
General
