Scheppach HL810 - Cleaning the Equipment; Cleaning Procedure; Transporting the Log Splitter; Transporting the Log Splitter Safely

www.scheppach.com
24
|
GB
Connections and repairs


Please provide the following information in the event

• 
• 
• 
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol
lowing parts are therefore also required for use as
consumables.
      
splitting wedge

Spare parts and accessories can be obtained from

the cover page.
16. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be re


terial, such as metal and plastic.
Defective components must be disposed of as spe

Old devices must not be disposed of with house-
hold waste!

not be disposed of together with domestic
waste in compliance with the Directive


posed of at a designated collection point. This can


     

for the environment and human health due to poten



 󰀨 
obtain information on collection points for waste


the disposal of waste electrical and electronic equip

14. Storage


The optimum storage temperature is between 5 and

Store the device in its original packaging.
Cover the electrical tool in order to protect it from
dust and moisture. Store the operating manual with
the electrical tool.
15. Maintenance
Attention!

tenance work on the equipment.
When must the oil be changed?

500 operating hours.
Oil change (g. 12)
• 
• Put a container with a volume of at least 6 litres
under the splitter.
• 
• Open the oil drain plug 12a under the oil tank so the

• Afterwards, close the oil drain plug 12a again.
• 

• Screw the oil dipstick in again.
Dispose of the used oil in a correct manner at a
public collection facility. It is prohibited to drop
old oil on the ground or to mix it with waste.

Splitting spar
    

       The spar
may never run dry.
Hydraulic system

pump and control valve.


Check the oil level regularly.

     
