Scheppach HM140L User Manual

www.scheppach.com
36
|
GB
14. Troubleshooting
Fault Possible cause Remedy
Motor does not work
Motor, cable or plug defective,
fuses burnt
Arrange for inspection of the machine by a
specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
The motor starts up
slowly and does not
reach operating speed.
Voltage too low, coils damaged,
capacitor burnt
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist. Arrange for replacement of the capacitor by
a specialist
Motor makes excessive
noise
Coils damaged, motor defective
Arrange for inspection of the motor by a spe-
cialist
The motor does not
reach its full power.
Circuits in the network are over-
loaded (lamps, other motors, etc.)
Do not use any other equipment or motors on
the same circuit
Motor overheats easily.
Overloading of the motor, insu󰀩-
cient cooling of the motor
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor
Saw cut is rough or
wavy
Saw blade dull, tooth shape not ap-
propriate for the material thickness
Re-sharpen saw blade and/or use suitable saw
blade
Workpiece pulls away
and/or splinters
Excessive cutting pressure and/or
saw blade not suitable for use
Insert suitable saw blade

Scheppach HM140L Specifications

General

Input power	2000 W
Power source	AC
AC input voltage	230 - 240 V
AC input frequency	50 Hz
Saw blade included	Yes
Number of blade teeth	48
Idle speed (max)	7000 RPM
Bevel type	Double bevel

Weight and Dimensions

Depth	750 mm
Width	590 mm
Height	500 mm
Weight	21030 g
Package weight	25660 g