www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
28
|
GB
2. Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling
• Non-compliance of the operating instructions
• Repairs by third parties, by not authorized service
technicians
• Installation and replacement of non-original spare
parts
• Application other than specied
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113
Please observe the following:
Read through the complete text in the operating in-
structions before installing and commissioning the
device.
The operating instructions are intended to help the
user to become familiar with the machine and take
advantage of its application possibilities in accord-
ance with the recommendations.
The operating instructions contain important informa-
tion on how to operate the machine safely, profes-
sionally and economically, how to avoid danger, cost-
ly repairs, reduce downtimes and how to increase
reliability and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regu-
lations that apply for the operation of the machine in
your country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information. The machine can only
be operated by persons who were instructed con-
cerning the operation of the machine and who are in-
formed about the associated dangers. The minimum
age requirement must be complied with.
In addition to the safety instructions contained in this
operating manual and the specic regulations of your
country, the technical rules generally accepted for the
operation of machines of the same type must be ob-
served.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
3. Device description
1. Saw table
2. Saw blade guard
3. Riving knife (not shown)
4. Saw blade (not shown)
5. Table inlay
6. Table width extension
7. Locking handle
8. Scale
9. Hand wheel
10. Crank
11. Machine stand
12. On/o switch
13. Eccentric lever
14. Parallel stop with knurled nut (i)
15. Guide rail, long
15a. Guide rail, short
15b. End caps
16. Suction adapter
17. Push stick
18. Bracket for saw blade storage
19. Legs
20a. Central strut A (2x)
20b. Central strut B (2x)
21. Rubber feet (4x)
22. Stand bracket (2x)
23. Fastening points
24. Table supports
25. Table inlay countersunk head screws
26. Riving knife xing screw
27. Screw with nut and washer
28a. Groove
28b. Groove
29. Knurled screw
30. Stop rail
31. Transverse stop with knurled nut (i)
32. Sight glass
32a. Screw on the sight glass
33. Laser
34. Laser switch
35. Screw for battery compartment
36. Battery cover
4. Scope of delivery
• Saw table with pre-mounted saw blade, 24 teeth
• Saw blade guard
• Riving knife
To Next Page
Loading...
Need help?
General
