To Next PageTo Next Page
Why does my Scheppach HS110 leave fire marks on the cutting surface?
If the Scheppach Saw creates fire marks on the cutting surface, it might be due to a blunt or wrong saw blade. You should sharpen or change the saw blade.
How to fix Scheppach HS110 when the blade dissolves after switching off the engine?
If the blade dissolves after switching off the engine of your Scheppach Saw, it is because the fastening nut is slightly tightened. To fix this, tighten the right hand thread nut.
What to do if the Scheppach HS110 Saw motor will not work, but the fuse is active?
If your Scheppach Saw motor won't work and the fuse is active, it could be due to an insufficient cross-section of the extension cable. Please refer to the 'Electrical connection' section for guidance. Alternatively, a blunt saw blade may cause an overload. Try changing the saw blade.
Why are there fire marks on the cutting surface of my Scheppach HS110?
If you notice fire marks on the cutting surface when using your Scheppach Saw, it's likely due to a blunt or wrong saw blade. You should sharpen the saw blade (only by an authorised sharpening specialist) or change it to resolve this issue.
What to do if my Scheppach Saw engine will not start?
If your Scheppach Saw's engine won't start, begin by checking the mains fuse. If the fuse is fine, the extension cable might be defective, requiring a replacement. In case the connections on the motor or switch are not in order, or the motor or switch itself is faulty, it's best to have it repaired by an electrical specialist.
How to fix a Scheppach HS110 blade that dissolves after switching off the engine?
If the blade of your Scheppach Saw dissolves after switching off the engine, it may be due to a slightly tightened fastening nut. To resolve this, tighten the right hand thread nut.
What to do if my Scheppach Saw motor won't work but the fuse is active?
If your Scheppach Saw motor isn't working but the fuse is still active, this could be because the cross section of the extension cable is not sufficient, refer to „Electrical connection“. Another potential cause is overload by a blunt saw blade, in which case you should change the saw blade.
How to prevent fire marks on the cutting surface with my Scheppach Saw?
Fire marks on the cutting surface when using your Scheppach Saw can occur due to a blunt or wrong saw blade. Try sharpening, changing the saw blade or using another one.
What to do if Scheppach Saw motor will not work, but the fuse is active?
General| Power | 2000 W |
|---|---|
| Blade Diameter | 254 mm |
| Max Cutting Height at 90° | 85 mm |
| Table Size | 640 x 487 mm |
| Weight | 23 kg |
| Saw blade bore | 30 mm |
| Motor | Induction motor |
| Input | 230 V |
| Motor Power | 2000 W |
